Landi Renzo Gas Injector TB/TU2565 GI25-80 Large White MED with AMP Connector

-35%

Category: GI-25 Series

Reference: 720007020

Brand: Landi Renzo

Approval Injector: E13 67R-010234 - E13 110R-000058

Approval Rail (holder): E13 67R-010233 - E13 110R-000057

Type and Variant: GI 25-80 TU2580 (TB2580) Large White

Manufacturer code: 237103001

Electrical connection: Bosch AMP 2 Pole

Injector size: Large GI 25-80

Factory systems: e.g. CITROEN DACIA OPEL RENAULT SEAT VW SKODA

Gas systems: Landi Omegas (Direct) / Eurogas Omegas / Landi LSI

FREE GAS FILTER type F-781 when ordering 3 or more injectors

€47.78 tax incl.

€73.50

Save 35%

Foreign companies with a valid VAT number shop VAT-free here! READ HOW.

- Delivery: 1-4 days

Safe Webshop

Webshop Trustmark & Secured by SSL. Your data and orders are safe here.

Delivery policy

Safe and Secure Shipping with DPD or DHL

Refund policy

Política de reembolso de 14 días y derecho de devolución

Landi Renzo LPG Injector GI25-80 Large White TB/TU2580 - MED RGI TB2580 (237103001) MED RGI AMP Connector

Suitable for the following gas systems:

- Landi Renzo Omegas

- Landi Renzo Omegas Direct

- Various Landi Renzo Factory systems: CITROEN, DACIA, OPEL (Corsa Meriva), RENAULT, SEAT, SKODA, VW, and others

- Eurogas Omegas 2.0 (from 2011) (Renault, Citroen, Peugeot, Volvo)

- Landi LSI

- NB! NOT SUITABLE FOR FIAT ALFA LANCIA

Important information regarding Gas Injectors

ATTENTION! Replace all injectors and use the correct injector size!

ATTENTION!

If you DO NOT replace ALL the injectors, there are many possibilities of differences between your new and old (contaminated) injectors, so the engine will still work badly and it may even seem that the new injectors do not work properly. All injectors are controlled with more or less the same injection time. The old injectors will dose more gas than the new injectors, because they are still accurate. Because the average mix is still too rich, the engine management will shorten the injection time, so that the new injectors will deliver even less. This will be particularly noticeable with a low engine load (idle) and much less noticeable with a higher engine load (not a high speed, but with the accelerator pedal well depressed).

Therefore it's important to replace all the injectors at the same time.

NB! USE THE SAME INJECTOR SIZE AS NOW USED ON YOUR CAR TO AVOID ADJUSTMENTS (SOFTWARE).

Replace the gas phase filter in time to prevent contamination of the gas injectors!

Replace the gas phase filter in time and regularly!

The filter lasts a maximum of 20,000 km. Preferably replace the filter earlier.
This replacement period applies with an average engine capacity of approximately 1.8L. Larger engines use more gas, which means the gas filter needs to be replaced sooner.
It is also possible that the LPG contains a lot of contamination (with oil and fats) at some refueling, which means that it is necessary to replace the filter earlier. Take this into account.
The timely replacement of the gas filter is necessary to prevent contamination of the gas system and gas injectors.

TIP!

Use 2 filters one after the other (in series) instead of just 1 filter. This allows you to prevent the contamination of the injectors even more when driving on a polluted LPG quality, for example. In this way there is a second filter that can still catch the excess paraffin.

Background information regarding gas injector problems

In most cases the problem is caused by the fact that the gas injectors are contaminated with paraffin (oils and greases from the LPG). The filter upstream of the injectors must ensure that the injectors do not contaminate quickly. This gas phase filter will eventually become saturated and must be replaced every 20,000 km. If the filter is not replaced, the paraffin will no longer be trapped and end up in the injectors. It is not the case that the injectors leak or do not open anymore. But the opening and closing time are no longer correct. The injectors remain open longer than they should (with dynamic behavior), which means that too much fuel is being dosed. (too rich mixture) The injectors will then deviate, especially with short injection times (low engine load). The engine is going to run messy and there are too large differences between the injectors. Cleaning the injectors often makes no sense, because there is often too much wear in the injector occurred, as a result of which the guide of the plunger (sealing disk) no longer has the right fit. The plunger does not go smoothly and lord, but goes up and down stumbling and wobbling. If the injectors are replaced without replacing the filter, the new injectors will soon become dirty again. (read symptom control, no long-term solution)

Application List Landi Renzo Injector White GI 25-80 Large

NB! This list is not complete and not 100% accurate and is for guidance only.

AUDI with an OEM LANDI RENZO system

AUDI A4 1.8T BFB

OPEL with an OEM LANDI RENZO system

OPEL ANTARA 2.4 Z24XE
OPEL ANTARA 3.2 HFV6
OPEL ASTRA H GTC TURBO 1.6 Z16LET
OPEL INSIGNIA 1.6L A16LET AM COM
OPEL MERIVA OPC Z16LET

RENAULT with an OEM LANDI RENZO system

RENAULT KOLEOS 2.5 TR25 4x2 C.
RENAULT KOLEOS 2.5 TR25 4x4 C.
RENAULT LAGUNA 2.0 SW M4RC7

SAAB with an OEM LANDI RENZO system

SAAB 9-7X 4.2
SAAB SAAB 9-3 1.8T B207E AM C.
SAAB SAAB 9-5 2.3T B235R AM C.
SAAB SAAB 9-3 2.0T B207R AM C.

Reference 720007020

Data sheet

Characteristic:: Size: Large Wit White TB2580 - AMP Bosch Connector
Right of Withdrawal: When connecting (Electric, Gas or coolant) to this product, the right of withdrawal expires.
Downloads:: Manuals and Documentation - See the tab Attachments on this page.
Related Products:: See bottom of this page
Shipping Cost:: Is calculated in the Checkout and is visible there. (Depends on total weight, destination and discounts.)
Application:: Landi Renzo, Eurogas Omegas

Condition New

Be the first to write your review!