Information

your content here

Reduced price! Drooggas Filter Prins VSI kunststof met 1 uitgang 180/80200/B View larger

Prins VSI Replacement Kit LPG Filter Plastic with 2 outlets

279614500

New

Prins VSI Replacement Kit LPG Filter Plastic with 2 outlets

Nederlands GA VERDER IN NEDERLANDS

More details

Beoordelingen en recensies

(4/5)
2 beoordelingen - 2 recensies

View distribution
Lees recensies Schrijf een recensie

35,79 €

-32%

52,64 €

Data sheet

CharacteristicPrins, VSI, Filter

More info

Prins VSI Replacement Kit LPG Filter Plastic with 2 outlets

Type: VSI (2 outlet) Filter: 180/802304/B

Set: 180/80044/C

Approval: E4 67R-010096

Exclusive Pressure sensor! (The Filter does have a sensor connection)

2 Gas Outlet

Connection Inlet: Gas hose with an internal diameter of 16mm

2 x Connection Outlet: Gas hose with an internal diameter of 11mm

Filtration: 10 Micron (High quality filter element)

Applicable for gassystems of:

- Prins VSI / VSI 2.0

- Eurogas Omegas until +- 2006 Using a Keihin injector rail

------------------------------------------------------------------

Renew your gas filter at least every 20,000 km This is to prevent contamination of the gas system and gas injectors.

 

Including Wet gas filter and O-rings: Liquid gas filter element for in the gas valve (Type Valtek) on the Prins VSI evaporator. This filter is used to filter hard particles (such as sand and iron) from the liquid LPG before entering the evaporator. Only suitable for the Valtek gas valve on the Prins VSI evaporator.

 

Background information regarding problem with gas injectors:

In most cases the problem is caused by the fact that the injectors are contaminated with paraffin (oils and greases from the LPG). The filter in front of the injectors must ensure that the injectors do not contaminate quickly. This filter will eventually become saturated and must be replaced every 20,000 km. If the filter is not replaced, the paraffin will no longer be trapped and end up in the injectors. It is not the case that the injectors leak or do not open anymore. But the opening and closing time are no longer correct. The injectors remain open longer than they should (with dynamic behavior), which means that too much fuel is being dosed. (too rich mixture) The injectors will then deviate, especially with short injection times (low engine load). The engine is going to run messy and there are too large differences between the injectors. Cleaning the injectors often makes no sense, because there is often too much wear in the injector occurred, as a result of which the guide of the plunger (sealing disk) no longer has the right fit. The plunger does not go smoothly and lord, but goes up and down stumbling and wobbling. If the injectors are replaced without replacing the filter, the new injectors will soon become dirty again. (read symptom control, no long-term solution)

Recensies

Door (GAANDEREN, Netherlands) op20 Jan. 2016 (Prins VSI Replacement Kit LPG Filter Plastic with 2 outlets) :
(5/5

Goedkoop

Goedkoop hier!

 Rappoteer misbruik
Door (Venhuizen, Netherlands) op20 Jan. 2016 (Prins VSI Replacement Kit LPG Filter Plastic with 2 outlets) :
(3/5

Snel

Snel en lage verzendkosten

 Rappoteer misbruik