Tank Fixation Ring Kit D. 230mm (2x Ring) incl. bolts & Nuts and Iso. Foam for LPG-Cyl. Tank / Vapour Tank

Tank Fixation Ring Kit D. 230mm (2x Ring) incl. bolts & Nuts and Iso. Foam for LPG-Cyl. Tank / Vapour Tank

Type: 2x Steel mounting ring for vapor tank mounting
Dimensions: Width: 40 mm, Diameter: 23 cm, Thickness: 3 mm

Product Content:
2x Mounting ring diameter 23 cm
1x Roll of adhesive insulation
 
(Angled metal strips (NOT SUPPLIED)

Basic Assembly Instructions:

Assemble the mounting rings in combination with Angled metal strips (or other construction material) into a sturdy and well-fitting tank frame for your vapor tank and vehicle. When you apply (weld) the mounting rings to the corner strip, make sure that the rings are in the closed position (as they hold the gas tank.) Otherwise, the corner strip may not come out at the correct angle to the rings.

Note the position and therefore the marking on the gas tank. And pay close attention to the position of the flanges of the rings in relation to the tank fittings (tank box), so that incoming and outgoing pipes are not blocked. Use a sufficient number of bolts of the correct quality for a sufficiently strong construction. (See RDW installation requirements.)
After the tank frame is fully prepared and sized, apply a coating and then apply the adhesive insulation.

The gas tank must not make any metallic contact with the tank frame. Therefore, use the supplied adhesive insulation and apply it to the inside of the mounting rings.

Position the gas tank on the prepared tank frame. (To do this, bend the rings slightly open.) Note the marking (cross with arrow) on the gas tank for correct positioning for proper operation of the gas tank. The mark indicates the top and the horizontal center plane.

No weakenings may be made in the mounting rings, for example by making a hole.
Use and respect the RDW installation requirements / NPR-2577 guidelines for correct installation.

 

Coating:

The mounting rings and corner strip are untreated. We advise to provide these with a protective coating after assembly and adjustments, such as the application of extra mounting holes and mounting brackets. Then apply the adhesive insulation.

 

TIP:
Provide the entire tank installation with a protective coating as soon as everything is properly fixed. This is particularly important in the case of substructures. This extends the life of the tank and construction. Preferably repeat this annually.

 
Advice:
Have the installation of the gas tank and the assembly of the tank frame done by an expert person or specialist company.

Have the entire installation inspected by a competent authority.